2-1/2 inch 35° Finish Nailer
Visit us at chpower.com
Close pressure
regulator, Turn
ON compressor and
Allow tank to reach
maximum pressure.
Attach air
CHN70600
1
2
hose to regulator
outlet. Adjust
regulator knob so
outlet pressure is
between 70 psi and
120 psi.
Setup Like a Pro
Easy Setup Guide
Screw
Projects are easier with
Campbell Hausfeld products.
70
psi
120
psi
Thank you for deciding to purchase a
Campbell Hausfeld product. We are dedicated
to providing tools that help you to complete your
projects Like a Pro.
NOTICE: To operate this tool you will need
at least a 1 gallon compressor.
© 2009 Campbell Hausfeld/Scott Fetzer
IN727601AV 6/09
Battery Replacement
Load fasteners. See manual for further information regarding length and type of fasteners.
Attach coupler on air
hose to nailer inlet.
3
4
Always disconnect the tool from
the power source when unattended,
performing any maintenance or repair, clearing a jam,
loading, unloading, or moving the tool to a new location.
Disconnect the tool from air source. Remove screw
and battery compartment cover. Insert two (2) new
batteries in the proper orientation. Do not mix old
and new batteries. Close cover. Replace screw.
Nail Pusher
Latch Button
Pull pusher back
until it latches.
Load nails.
Press pusher latch button and
allow pusher to ride against nails.
Setup Like a Pro
CHN70600 — Air Powered Angle Finish Nailer
|
Bernard Welder SPEC NC 11 User Manual
Blodgett Hot Beverage Maker KTG E User Manual
Bosch Appliances Home Security System 20 User Manual
Bosch Appliances Home Security System LBB3580 User Manual
Bosch Power Tools Drill PS30 User Manual
Breville Kitchen Grill BGR200XL User Manual
Brinkmann Cell Phone 844 0350 0 User Manual
Campbell Hausfeld Air Compressor IN634000AV User Manual
Cannon Washer IWD User Manual
Canon Scanner 2924B002 User Manual